analysis type "static" not recognized by simulator

Hi all,

I've tried posting this question in a different forum, and the furthest I could get was that the code works for everybody else. I'm trying to design a switch which turns on when the analysis is type "static" and off otherwise. The code is shown below.

`include "constants.vams"
`include "disciplines.vams"
module analysis_switch(vp,vn);
inout vp, vn;
electrical vp, vn;
analog begin
 if( analysis("static"))
   V(vp, vn) <+ 0.0;
 else
   I(vp,vn) <+ 0.0;
end // analog
endmodule

In simulation, the switch is off no matter what analysis I run. I have tried changing line 7 to if(analysis("dc")) and the code works fine. However, I want the switch to work for the operating point of ac, sp etc. Seems to me that there is a setup problem. Does anybody know how I can fix this?

thanks,

Aaron