Stats

  • Locked Locked
  • Replies 0
  • Subscribers 65
  • Views 1082
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

SimVision: group bytes of SPI MOSI/MISO data

bdel

Hello,

Not sure this is possible, but I'll put it out there.

For those not familiar with SPI, its pretty much CS gets asserted, from then on each rising (or negedge depending) of clock you sample a input and an output signal until CS deasserts.

So, kinda like is done for buses, where grouping signals together makes them easier to view on the waveform, is it possible to see 8 clocks of the MOSI/MISO (the input and output serial data lines in SPI) grouped together?

There is the expression calculator, but it doesn't seem advanced enough to describe the protocol in enough detail that it could render what I'm looking for on the waveform. But, I thought I'd ask to be sure.

Thanks,

Ben

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.