Stats

Locked Locked
Replies 0
Subscribers 65
Views 13032
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Combine interactive mode and regular mode

Hi There,

I want to run interactive mode since my simulation hangs and want to find out the loop. I have a tcl file which containts huge number of force statements and it takes extremely long time to let all force statement to finish. I believe, this happen due to continuous transfer of control between tcl and tb. I want to set a break point after all the force statement executes. So basically, till I finish all force statements from tcl, I want let irun run in regular mode and then after it want to switch to interactive mode to debug the loop.

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.