Stats

Locked Locked
Replies 0
Subscribers 65
Views 12700
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Help with Optimizer (model parameters)

Greetings.

Is there some way to use Optimizer (Orcad PSpice 16.5) in order to optimize model parameters (in the actual case, N and IS of a diode) and achieve fitting of the experimental data?

I read on the internet that it should be possible, but I was not able to make Optimizer recognize the two model parameters as optimizing parameters.

Thanks

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.