Stats

  • Locked Locked
  • Replies 2
  • Subscribers 66
  • Views 16770
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Regression Testing in UVM

Eliz

I would like to know if it is possible to run different test cases in regression mode in a single simulation in NCSIM. My test bench consists of Xilinx MIG which needs to be calibrated (takes time) before simulation. Right know this initialization needs to be repeated for each and every test case(while running regression) which is time consuming.
I would like to know if test case 2 can start after test 1 ends (from that instant) rather than beginning from time 0 so that the calibration needs to be done only once at the start of regression test ?

Parents
  • Eliz
    Thank you Steve. Its in UVM. Let me try out.
Reply
  • Eliz
    Thank you Steve. Its in UVM. Let me try out.
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.