Stats

  • Locked Locked
  • Replies 0
  • Subscribers 65
  • Views 10165
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Indago waveform is not showing after Design reload

Abhishek Jaiswal

Hi,

I am facing the issue where indago waveform goes blank after I reload design. Below are the steps 

1. I simulate and open the waveform in indago

2. find the RTL issue, fix it and re-run

3. reload the design after test is done.

After step 3, 70% time it is okay but 30% time it does not reload correctly and all the waveform window is blank. (though signal name is still visible)

If I close indago, (remove myDb and rerun the test it works fine.

What could be the issue?

Abhishek

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.