Stats

Locked Locked
Replies 1
Subscribers 65
Views 7963
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[Simvision] Getting a signal range

Moamin over 2 years ago

hello sir, i have many signals like S_l1[25920:0].

so i use 'probe -create S_l1 -packed 25920' command.

my question is that 'is there any possible way to seperate this signal like S_l1[95:0], S_l1[191:96] ...

because when i get that signal, i can only see entire signal like S_l1[25920:0].

thank you.

StephenH over 2 years ago

Your question is really not clear. Are you asking how to change the display of the signal in the waveform window?
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.