Stats

Locked Locked
Replies 1
Subscribers 62
Views 14339
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Setting a MAX value for fan_Out ( or slew rate)

Hi everyone,

I was wondering whether it is possible to set a maximum value for fan-out (or the slew rate) at the output of each cells during synthesis, I've seen some commands however they mostly are for the output pins and not applicable for the output of each cell. Is there any command in RC that can do it?

Regards,

Medya

Parents

grasshopper over 8 years ago

genus@root:> set_max<TAB>
set_max_capacitance set_max_delay set_max_dynamic_power set_max_fanout
set_max_leakage_power set_max_time_borrow set_max_transition

hope this helps,
gh-
Cancel
Vote Up 0 Vote Down

Cancel

Reply

grasshopper over 8 years ago

genus@root:> set_max<TAB>
set_max_capacitance set_max_delay set_max_dynamic_power set_max_fanout
set_max_leakage_power set_max_time_borrow set_max_transition

hope this helps,
gh-
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.