Stats

  • Locked Locked
  • Replies 4
  • Subscribers 65
  • Views 15442
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

component display

40Ford

Using IC61 Schematic Editor.

 In an open schematic I select "Edit -> Component Display" and on the Edit Component form I select 'parameter' for "Select Label" and under Parameter Labels I select 'library' for "Apply To" and then operating point and DC.

 When I select a device from the schematic the form automatically switches to 'parameter' and 'full'. If I manually switch it back to 'operating point' there are no Display values listed.

 Another user pointing to the same data with the same version of virtuoso is able to list several labels and select numerous OP parameters.

Why would this form behave differently for different users?

 Cheers

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.