Stats

  • Locked Locked
  • Replies 4
  • Subscribers 64
  • Views 13939
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Model parameters unit

Nadidjka

Hello all,

Can someone please tell me what is the unit of the model parameters in cadence? Are the capacitance values measured per unit width or they're just in Farad?

Thank you,

Nadida

Parents

  • If you look at the model file, you should be able to find the definition of the model, and see what "type" it is. If it's called XXX_mac (assuming this is using a particular well-known foundry's naming), then it's  a macro model, and so in itself it is probably a subckt model. In the definition of the subckt, you'll find an instance of a transistor, and then find the model it calls - and you can hunt down the model definition - in the form:

    model pch bsim4 ...

    or similar. If you just type "spectre -h" you'll get generic help on command line options, analyses, and available component types. "spectre -h bsim4" or "spectre -h bjt" will give you help on a specific model type.

    Now you mention cgd, csd, and so these are probably operating point parameters, not model parameters. Still, the units of those are given too in the help (although they are partial derivatives, so may not be quite what you're expecting, if indeed it is the operating point output parameters that you're talking about).

    Note you can also type "spectre -help bsim4"

    Regards,

    Andrew.

Reply

  • If you look at the model file, you should be able to find the definition of the model, and see what "type" it is. If it's called XXX_mac (assuming this is using a particular well-known foundry's naming), then it's  a macro model, and so in itself it is probably a subckt model. In the definition of the subckt, you'll find an instance of a transistor, and then find the model it calls - and you can hunt down the model definition - in the form:

    model pch bsim4 ...

    or similar. If you just type "spectre -h" you'll get generic help on command line options, analyses, and available component types. "spectre -h bsim4" or "spectre -h bjt" will give you help on a specific model type.

    Now you mention cgd, csd, and so these are probably operating point parameters, not model parameters. Still, the units of those are given too in the help (although they are partial derivatives, so may not be quite what you're expecting, if indeed it is the operating point output parameters that you're talking about).

    Note you can also type "spectre -help bsim4"

    Regards,

    Andrew.

Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.