Stats

Locked Locked
Replies 3
Subscribers 64
Views 13884
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Slow ncls in AMS

Hi, I am in the process to convert a Spectre/APS testbench into an AMS/APS testbench. I can simulate my old pure analog testbench with AMS/APS with the expected results. After I added a very simple verilog/AMS view and connected it to the DUT in my testbench and press the run button in ADE, I noticed there is a ncls process running for about 10 minutes before elaboration. What does it do and why is it so much slow?

ncls -64bit -verilog -f /mytb/ams/config/netlist/findPackageOpt

// IC subversion: IC6.1.6-64b.500.14
// IUS version: 15.20-s004

Thanks,
TJ

Parents

twen over 9 years ago

Hi, Andrew,

I switched back to INCISIVE 14.20.014 and ncls won't stall any more.

Thank you very much,

TJ
Cancel
Vote Up 0 Vote Down

Cancel

Reply

twen over 9 years ago

Hi, Andrew,

I switched back to INCISIVE 14.20.014 and ncls won't stall any more.

Thank you very much,

TJ
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.