Stats

Locked Locked
Replies 0
Subscribers 64
Views 818
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Is there a way to change the value of a voltage source (or a generic parameter), "during" the execution of an Interactive mode AMS simulation?

Hello all,
I was wondering if there is a way to change the value of a voltage source interactively, during the execution of an AMS simulation.
In SimVision, I can not deposit a value on a VerilogA model parameter, like DC value or delay.

An example would be how to create the following waverform with user commands:

Any help or idea will be very much appreciated.

Many thanks in advance and best regards,
Ardit

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.