Stats

Locked Locked
Replies 2
Subscribers 64
Views 2362
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Virtuoso ADEXL cluster(SGE) simulation

Dear all,

I would like to know how to configure Virtuoso ADEXL setup to use cluster for simulation. We have SGE cluster installed.

Best regards,

Rizwan

Parents

Andrew Beckett over 6 years ago

Did you read the section in the ADE XL manual "Setting Up Job Policies"? I searched for "Sun Grid Engine" in the entry box at the top of the Help menus in Virtuoso and found this, but better still would be to search for "Setting Up Job Policies" and then it will explain this.

Andrew.
Cancel
Vote Up +1 Vote Down

Cancel

Reply

Andrew Beckett over 6 years ago

Did you read the section in the ADE XL manual "Setting Up Job Policies"? I searched for "Sun Grid Engine" in the entry box at the top of the Help menus in Virtuoso and found this, but better still would be to search for "Setting Up Job Policies" and then it will explain this.

Andrew.
Cancel
Vote Up +1 Vote Down

Cancel

Children

riahm over 6 years ago in reply to Andrew Beckett

Andrew

Thanks for the response. To be honest I have not read the documentation about setting up jobs on a cluster. I read now and if I don't understand something I will write the specific question.

Best regards,

Rizwan
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.