Stats

Locked Locked
Replies 3
Subscribers 65
Views 12542
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

AMS simulation speed

Hi,

I am running AMS, transient simulation for the stop time = 500u.... it takes around half an hour. I don't know if it is typical or not.

Anyway, is there any way to decrease the AMS simulation time and make it faster?

BTW, in my simulation setup I have some Analog parts,a few Verilog described blocks and also two Verilog-A described blocks.

Thanks

Mostafa

Mostafa A over 4 years ago

Hi,

I am running AMS, transient simulation for the stop time = 500u.... it takes around half an hour. I don't know if it is typical or not.

Anyway, is there any way to decrease the AMS simulation time and make it faster?

Thanks

Mostafa
Cancel
Vote Up 0 Vote Down

Cancel
ShawnLogan over 4 years ago

Dear Mostofa,

From my perspective, your question is too vague for me to provide any specific information regarding decreasing your simulation time.

Sorry,

Shawn
Cancel
Vote Up 0 Vote Down

Cancel
Ring Lewis over 4 years ago

0.5h for a 500us simulation is quite normal for me.

If you have set APS and it's still slow, then try Ultrasim, ADEL-Simulation-Solver
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.