Stats

Locked Locked
Replies 11
Subscribers 64
Views 14160
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to read output of a 32bit bus in a transient simulation using Spectre ?

HI,

I know how to use a vector file to write to input buses. But how can we read the output of buses and for example transfer the results to a file?

Is there any verilogA code for that?

Thanks,

-Mehrdad

ShawnLogan over 3 years ago in reply to Mdad

Dear Mdad,

Thank you - I was very happy to read our responses provided a bit of insight! Good luck!

Shawn
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.