• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Mixed-Signal Design
  3. Attach load to a pin for AMS verification

Stats

  • Replies 0
  • Subscribers 64
  • Views 30
  • Members are here 0

Attach load to a pin for AMS verification

PedroC
PedroC 16 hours ago

Hi,

I would like to have a voltage/current source that I could attach to any pin (programatically maybe). For example, I may need to pull the output of an LDO to ground.

How can I have a source that I can refer to the pin I want it to be attached to in order to create an over-voltage or under-voltage?

Kind regards,

Pedro

  • Sign in to reply
  • Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information