Stats

  • Locked Locked
  • Replies 4
  • Subscribers 63
  • Views 13362
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Syminductor layout problem

peter450

 Hi,

I'm implementing a design that has syminductor.When I'm running LVS I'm getting parameter mismatch

"wu" layout 1.44e-5 schematic -1e-6

But the values of wu for schematic and layout are same in the design.

Parents
  • Nobody is going to be able to help you unless they know which technology you're using and which specific design kit version you're using. The software version wouldn't go amiss either.

    Then there's a chance somebody might be familiar with the specific problem.

    The name "syminductor" doesn't give much of a clue... (I could guess the foundry, but not which design kit it is for)

    Andrew
Reply
  • Nobody is going to be able to help you unless they know which technology you're using and which specific design kit version you're using. The software version wouldn't go amiss either.

    Then there's a chance somebody might be familiar with the specific problem.

    The name "syminductor" doesn't give much of a clue... (I could guess the foundry, but not which design kit it is for)

    Andrew
Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.