Stats

Locked Locked
Replies 3
Subscribers 63
Views 13439
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

symbolic pin in IC6

I don't know if this is the right place for my question.

Recently i begin to use IC6.1, and i need to put a name to some metal lines. In IC5, i used symbolic pin for this, but in cadence 6 i dont know how can do. I try use Netname in metal layer, but when i extract the device, the netname change.

How can i put a name in a net in layout view? I need know V in this net after simulation.

Thanks in advance and sorry for my english.

Parents

Telekito over 13 years ago

I have already solved. My problem was i was using a wrong layer.
Thank you so much
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Telekito over 13 years ago

I have already solved. My problem was i was using a wrong layer.
Thank you so much
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.