I have recently installed a new Model Library, and am unable to see the DC Operating Points on the schematic diagram after clicking on Results->Annotate->DC Operating Points in Virtuoso ADE. I am using ADE 5.10 and USR6.127.
I wonder if anyone has any suggestion on how to resolve this issue.
Thank you for your prompt attention and the remark. I also was under the impression that the issue was design-kit-related; however, one of my colleagues is using the same design kit, and he is able to view the DC Operating Points.
Nevertheless, I am using Revision 1.0 of the BCS180G design kit by HHNEC (http://www.hhnec.com).
Given the above, I wonder if there is any setup that I need to do in Virtuoso ADE, CIW, or elsewhere to resolve the issue. Please advise.