DC Operating Points not displayed on Schematic Diagram (ADE 5.10; USR 6.127)

This is likely to be related to the design kit  you're using - perhaps you can state which design kit, and which version of that design kit you're using - maybe there's somebody on the forum who is familiar with it and can advise?

Andrew.

Hello Andrew,

Thank you for your prompt attention and the remark. I also was under the impression that the issue was design-kit-related; however, one of my colleagues is using the same design kit, and he is able to view the DC Operating Points.

Nevertheless, I am using Revision 1.0 of the BCS180G design kit by HHNEC (http://www.hhnec.com).

Given the above, I wonder if there is any setup that I need to do in Virtuoso ADE, CIW, or elsewhere to resolve the issue. Please advise.

Thank you.  

Andrew,

Updated information:  when I use Results->Print->DC Operating Points in the Virtuoso ADE, I can see the DC Operating Points in the "Results Display Window;" as such, it appears that the issue is not design-kit-related, as the data exist but are not displayed on the schematic diagram.

I hope this helps identify the cause of the issue.

Thank you.

Hello,

Pls check your model files..these may be hspice model. we also faced the similar problems when using hspice models but resolved it by using spectre model files.

regards