Stats

Locked Locked
Replies 4
Subscribers 64
Views 15348
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DC Operating Points not displayed on Schematic Diagram (ADE 5.10; USR 6.127)

All,

I have recently installed a new Model Library, and am unable to see the DC Operating Points on the schematic diagram after clicking on Results->Annotate->DC Operating Points in Virtuoso ADE. I am using ADE 5.10 and USR6.127.

I wonder if anyone has any suggestion on how to resolve this issue.

Thank you.

Parents

ECILCadence over 9 years ago

Hello,

Pls check your model files..these may be hspice model. we also faced the similar problems when using hspice models but resolved it by using spectre model files.

regards
Cancel
Vote Up 0 Vote Down

Cancel

Reply

ECILCadence over 9 years ago

Hello,

Pls check your model files..these may be hspice model. we also faced the similar problems when using hspice models but resolved it by using spectre model files.

regards
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.