I am trying to do post-processing on my output signals in MATLAB using the SpectreRF toolbox. I use the cds_srr() command in MATLAB to import the signal data into MATLAB and take it from there. However, each time I re-run a simulation in spectre which a change in some parameters that will change the output waveforms as well, the new updated data is not imported in MATLAB on re-typing the command. I need to close MATLAB window and restart it to get the new data. Any thoughts on this issue?
Sorry about that! I thought it would be common to all since its a MATLAB command.
Here is the version details:
Virtuoso Ver: 184.108.40.2060.12
MATLAB Ver: 2011b
I don't think it should be data dependent though because I am just importing waveform data into MATLAB like you would do for any other data. I am just running a 'transient' and yes I wait enough after completion of transient simulation for the new data to be saved, in case it takes time to write in a file.