Stats

Locked Locked
Replies 2
Subscribers 62
Views 14540
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to do LVS when there is an NPORT?

I had to design my own transmission lines in layout and I have used HFSS to EM simulate the structure and then I use the result by employing NPORT in my schematic.

The problem is that I cannot run LVS since it does not produce netlist for a schematic that contains NPORT.

Any idea how I can run LVS while keeping my transmission line?

Best

Parents

HamidKhatibi over 11 years ago

Thank you so much Andrew.
Finally I replaced the TL with PINs to do the LVS.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

HamidKhatibi over 11 years ago

Thank you so much Andrew.
Finally I replaced the TL with PINs to do the LVS.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.