Stats

  • Locked Locked
  • Replies 3
  • Subscribers 64
  • Views 18086
  • Members are here 0
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Simultaneous Load-pull and source-pull simulation in cadence

HamidR

Hi there,

Happy holidays and new year. I wonder if cadence has an option similar to ADS to simultaneously simulate source-pull and load-pull for simultaneous conjugate matching. Only simulating load-pull returns meaningful contours for the optimum load conditions. However, doing the same thing on the source side returns few points and does not really seem to optimize the input power. For these simulations, we use the adapter from the rfExamples library. Is there a different setup to simulate the source pull conditions? And also are there any chances to perform both source-pull and load-pull in one run of sims in one testbench?

Many thanks in advance,

Hamid

Parents Reply Children
No Data

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.