Stats

Locked Locked
Replies 4
Subscribers 63
Views 15393
Members are here 0

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

substrate layer of inductor

Hello, I have built an inductor as shown bellow, there are two layers layer 9 and layer 8 with a VIA connecting between them.

There are 3 layers where a substrate could be defined.under layer 9, between layer 9 and layer 8 and above layer 8.

The only option i have is to load a file , but can i define it manualy some how?

Thanks

Parents

Andrew Beckett over 6 years ago

Momentum is a tool from Keysight, not Cadence (see the banner of the Momentum window). You would be better off asking this question to Keysight - either their customer support or here: https://community.keysight.com/community/discussion-forums/eda-software

Regards,

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Andrew Beckett over 6 years ago

Momentum is a tool from Keysight, not Cadence (see the banner of the Momentum window). You would be better off asking this question to Keysight - either their customer support or here: https://community.keysight.com/community/discussion-forums/eda-software

Regards,

Andrew
Cancel
Vote Up 0 Vote Down

Cancel

Children

yefJ over 6 years ago in reply to Andrew Beckett

yes , thank you very much.
Cancel
Vote Up 0 Vote Down

Cancel
yefJ over 6 years ago in reply to yefJ

Hello Andrew, i didnt mean to ask questions that are not the subject ofthe forum because it was semi cases.every semi case i adressed to Keysight site you said.

Could you please help me with the injection lock issue.when i tried to post it, it showed that my post is spam.

Thanks
Cancel
Vote Up 0 Vote Down

Cancel
Andrew Beckett over 6 years ago in reply to yefJ

I have no idea what you mean by "because it was semi cases".

I have found your other posts in moderation - normally I don't get notified unless you appeal the moderation (which you didn't do) - it had put them into moderation because of repeated text in the posts, which is often a sign of spam. Anyway, I've taken them both out of moderation and approved them.

Regards,

Andrew.
Cancel
Vote Up 0 Vote Down

Cancel

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.