Stats

  • State Not Answered
  • Replies 5
  • Subscribers 43
  • Views 14178
  • Members are here 0
More Content

Capture part name length more than 31 characters?

nickwallis

Hi,

Does anyone know if it is possible to increase the 31 character limit for part names in Capture? I am getting the following error whilst importing some library XML:

XMATIC : ERROR(ORDBDLL-1099): Illegal name length. Maximum name length is 31 characters

I can work around this but it would be better not to have this limitation.....

thanks

-Nick

Parents
  • oldmouldy
    0

    This looks like a "built in" limitation of the Name Length and there doesn't appear to be a setting that controls this.

Reply
Children
  • AvengerThanos
    0 in reply to nickwallis

    You can change the limit to 255 max under Tools - create netlist - setup - change the min value 31 to 255 - Ok

  • nickwallis
    0 in reply to AvengerThanos

    Thanks, but that's not the same thing.

    My question was about the maximum length for the part name (that is, the "Name" field when you add a new part to an OLB) - like the below image.

    -Nick

  • AvengerThanos
    0 in reply to nickwallis

    You will be permitted to have more than 31 characters, only if the above settings are done. I could type part name of 42 characters without any issue because of the settings done.

    Refer below images.

                         

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.