Stats

State Not Answered
Replies 4
Subscribers 45
Views 10553
Members are here 0

Power pins reported in DRC as output?

I have a schematic (handed to me) that is reporting most (if not all) GND net pins as a DRC error:

Error(ORCAP-1628)
ERROR(ORCAP-1628): Possible pin type conflict
X2,GND Power Connected to Output

Every one of these instances is a standard GND symbol from the Orcad library connected to a ground pin on an IC...and in every case the pin direction is set to POWER, not OUTPUT.

Why is the DRC tool identifying pins clearly set to POWER as OUTPUT pins?

Parents

0 AvengerThanos over 3 years ago

There will be a DRC marker on the component with a possible pin-type conflict. Select the component and go to the edit part. You could check the pin types of each pin there to get the issue resolved
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 AvengerThanos over 3 years ago

There will be a DRC marker on the component with a possible pin-type conflict. Select the component and go to the edit part. You could check the pin types of each pin there to get the issue resolved
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.