Stats

More Content

orcad capture breakout

Liao hi

The orcad capture always breakout when I use the command "make root".   it shows the message "ERROR(ORCAP-1356):memory exhausted, you can close and/ or release memory in other applications and retry Note that a cancel immediately exits the application"

Parents
  • Akshay khosla
    0

    Hi Liao,

    Please let us know the SPB tool version you are working on (like SPB22.1 or SPB23.1) also confirm if this is a design specific issue or reproducible on multiple designs.

Reply
  • Akshay khosla
    0

    Hi Liao,

    Please let us know the SPB tool version you are working on (like SPB22.1 or SPB23.1) also confirm if this is a design specific issue or reproducible on multiple designs.

Children
  • Liao hi
    0 in reply to Akshay khosla

    Thanks! The SPB tool version is SPB17.4. and the patch (Hotfix_SPB17.40.035) has been installed. 

  • Liao hi
    0 in reply to Akshay khosla

    I have found the reason. The breakout because of the "online DRC". you should turn off the "online DRC" in the desgin rules check if there are a lot of DRC error. The online DRC will autorun when i use the make root. Hope this can help others.

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.