Stats

  • State Not Answered
  • Replies 1
  • Subscribers 44
  • Views 298
  • Members are here 0
More Content

Cross probing accumulating in Capture, instead of synchronizing to what is currently selected

ersgfserg645

Hi,

I'm on Allegro 25.1, I have a design where cross probing is acting weird, it is as if when I select parts in PCB Editor they are just added to the list in Capture, they are not removed from the list when I deselect them in PCB Editor, meaning that more and more parts are selected in Capture each time I deselect and select a new part in PCB Editor, when I really just wanted to step through the parts one by one.

Any ideas to why this might be so?

It works perfectly fine in a demo design.

Parents
  • TechnoBobby
    0

    Hi  ,

    Since the issue appears to be specific to your design environment and may require a closer look at your project setup, we will reach out to you through another communication channel to investigate this further.

Reply
  • TechnoBobby
    0

    Hi  ,

    Since the issue appears to be specific to your design environment and may require a closer look at your project setup, we will reach out to you through another communication channel to investigate this further.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.