Stats

Replies 5
Subscribers 162
Views 12301
Members are here 0

Trimming specific shape refer to other layer shape

Hi All

there is 2 different layer shapes, the one shape is made by following the Cline of +12V net which is highlighted (red color), the other is large GND net (yellow)

I want to cut the red shape refer to the yellow shape boundary. I tried to cut using Shape Operations function, but it didn't do well that I want

that is just sample test, actual board that I design has quite complex shape (not retangle) so I need that function.

Is there any good way to solve this problem?

regard.

Parents

Wild over 4 years ago

If it is a dynamic shape, you could create a cline line seg with the appropriate clearance (DRC). Then make the shape static and delete the cline seg.

If you need the shape to be dynamic, I would create a anti ecth before updating the dynamic shape.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Wild over 4 years ago

If it is a dynamic shape, you could create a cline line seg with the appropriate clearance (DRC). Then make the shape static and delete the cline seg.

If you need the shape to be dynamic, I would create a anti ecth before updating the dynamic shape.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.