• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Allegro X PCB Editor
  3. DRC Driven Same Net Spacing Clearance Working for Through...

Stats

  • Replies 3
  • Subscribers 161
  • Views 10293
  • Members are here 0
More Content

DRC Driven Same Net Spacing Clearance Working for Through Pins but Not SMD Pins

l3hrbonini
l3hrbonini over 4 years ago

As stated in the title, DRC driven clearance appears not to work for SMD pins, but does work for through-pins.  I can add properties for clearance and type to the SMD pin and that will work just fine, but relying on the constraint and global parameters just results in a full contact connect.  I've looked through global parameters and constraint manager and everything looks correct to me, and is the same for both through and SMD pins.  Is there somewhere else I should be looking?

  • Sign in to reply
  • Cancel
Parents
  • excellon1
    excellon1 over 4 years ago

    You might want to verify that the actual DRC mode for Same Net Spacing is enabled. On the cm tool bar click on analyze > Analysis Modes to verify that.

    • Cancel
    • Vote Up 0 Vote Down
    • Sign in to reply
    • Cancel
Reply
  • excellon1
    excellon1 over 4 years ago

    You might want to verify that the actual DRC mode for Same Net Spacing is enabled. On the cm tool bar click on analyze > Analysis Modes to verify that.

    • Cancel
    • Vote Up 0 Vote Down
    • Sign in to reply
    • Cancel
Children
  • l3hrbonini
    l3hrbonini over 4 years ago in reply to excellon1

    Ok, checked that.  Everything under Same Net Spacing "SMD Pin to" is set to "On".  I've worked with OrCAD for a number of years and haven't seen this particular behavior before.

    • Cancel
    • Vote Up 0 Vote Down
    • Sign in to reply
    • Cancel
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information