Stats

State Suggested Answer
Replies 2
Answers 1
Subscribers 161
Views 6973
Members are here 0

DRC for shape minimum width

JanMironkiewicz over 2 years ago

Hi,

is it possible to setup DRC which will point necks in dynamic shapes? example below:

Parents

0 avant over 2 years ago

Under shape parameters, you can set the minimum aperture gap value. This should void out shapes smaller than the value.

I don't know if there is a DRC setting for minimum shape neck width.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 steve over 2 years ago in reply to avant

There is a Shape - Check command that checks based on the minimum aperture value. More relevant to Static Shapes because a Dynamic shape would void out the area smaller.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Reject Answer

Cancel

Reply

0 steve over 2 years ago in reply to avant

There is a Shape - Check command that checks based on the minimum aperture value. More relevant to Static Shapes because a Dynamic shape would void out the area smaller.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Reject Answer

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.