Stats

  • State Suggested Answer
  • Replies 4
  • Answers 1
  • Subscribers 160
  • Views 8585
  • Members are here 0
More Content

Drill hole size vs finished hole size chart

PCB6453

On my drill chart, they all call out for the "finished size" for all holes (through hole, blind vias, and microvias).  The fabrication house that I talked to requested to have the drill size shown instead of the finished hole size for microvias only.  Is there a way to show the drill size instead of the finished hole size on the drill chart?  Or can I show both?

Thank you.

MG

Parents
  • masamasa
    0

    manunfacture --> nc --> drill customization on the menu shows u the drill customization dialog.

    it automatically generates the hold size and hole count.

    u can generate the report file in csv as well.

  • PCB6453
    0 in reply to masamasa

    Masamasa,

    I was hoping to generate a chart that calls for "Drill_Size" for the microvias without me having to manually change it all the time.  For now, I change the "FINISHED_SIZE" to "DRILL_SIZE" for the microvias.

Reply
  • PCB6453
    0 in reply to masamasa

    Masamasa,

    I was hoping to generate a chart that calls for "Drill_Size" for the microvias without me having to manually change it all the time.  For now, I change the "FINISHED_SIZE" to "DRILL_SIZE" for the microvias.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.