Stats

More Content

gerber out question

masamasa

hello

 

i would like to have an outline shape placed on "substrate geometry/outline" exported as gerber but the gerber file is empty and gives me the following warning.

 

how can i export the outline shape as gerber?

 

can the outline shape have no 0 width line?

 

should i convert the outline shape to a line?

 

how can i change a shpae to a line?

 

regards

masa

Parents
  • steve
    +1

    You could try setting the undefined line width for that artwork film to 0.001mm (or something similar) and see if that helps. If it doesn't use Shape - Decompose Shape then set the options pane as required and convert the shape to lines. Give these a thickness (hover right click - Change Width) then try again,

Reply
  • steve
    +1

    You could try setting the undefined line width for that artwork film to 0.001mm (or something similar) and see if that helps. If it doesn't use Shape - Decompose Shape then set the options pane as required and convert the shape to lines. Give these a thickness (hover right click - Change Width) then try again,

Children
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.