converting pins to vias

Hi Masa,

The actual symbol has to have pins otherwise there is no net info. I think the best you can do is to change the physical padstack associated with each pin so 
it is of similar size to a via.

Best Regards.

thank u for ur response.

removing pins from a symbol is no problem. 

the problem is to place vias at the same locations wherre the pins were.

 i found a way to do this.

1. export a pin layer as a dxf file

2. import it back to the design

3. convert lins to shapes and shapes to vias.

regards

masa

Hi Masa!

Can you refer this code

I hope this is your solution

HoangKhoi

thank you for ur reply, hoangkhoi

i have tried ur skill but get this error.

regards

masa

thank you for ur reply, hoangkhoi

i have tried ur skill but get this error.

regards

masa

Hi Masa!

It's working on Allegro 17.4. I think you're opening the APD license,

or you should comment out lines 5 and 6, then try again

HoangKhoi