Stats

State Not Answered
Replies 2
Subscribers 160
Views 756
Members are here 0

acute angle

hello:

is there a way to detect a location with acute angle shapes?

the edit property has a setting for the acute angle to avoid having acute angle.

but i would like to find the acute angle location on the deisgn that was made by our customer and has many acute angles.

regards

masa

0 steve 1 month ago

Yes, Setup - Contsraints - Modes - Design and then Acute angle Detection, set an angle andf type and enable the DRC to on.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel
0 masamasa 1 month ago in reply to steve

thank u for your response, steve.

yes, it works for 90% of the cases.

however, it does not work on the situation where a fillet creates an acute angle and a shape and a padstack intersect each other.

regards

masa
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.