Stats

  • State Not Answered
  • Replies 0
  • Subscribers 159
  • Views 31
  • Members are here 0
More Content

Spacing Rounding Error in OrCAD X PCB 24?

kevcon

Hi,

I recently installed HOTFIX 006 and noticed that there is a 0.0002mm error in the clearance between two overlapping shapes when the spacing is set to 0.3mm.

I'm not sure if this has always been present, I don't have an older version installed anywhere at the moment to check.

I know this is a small error, but it throws me off when I am trying to double check the alignment of things on the board.

Has anyone seen this error on version 24 prior to HOTFIX 006?

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.