Differential pair pad entry

Hi in your second picture you have DRC's so there may be spacing issues with the trace to pad on the left side. What DRC's are reported ?.

There are a couple of methods to route in diff-pairs, Regardless of the etch style, When you route off the pin it should typically look like what you have in the first picture.
Since the pins in pic 2 are fairly close try this.  click on the pin and route off the pin a short distance then left click to stop routing. Next right click and choose target > route from target and you should see the etch auto start from the other end of the diffpair. Continue routing to join the etch up.

Where the etch comes off the pin it should gather the same as each end of the net.

DRC is because of the angle that the trace is routed into the pin 

But that's why I'm asking help, I'm not able to change the entry of the trace into the pin, the steps you told me does not help me with my problem. 

Have a look at Setup - User Preferences - Route - Connect and padentry_factor. This may help.

I don't see the padentry_factor on user preference

Try clicking on the Next button..... you can also type that into the Smart Search...