Stats

  • Replies 14
  • Subscribers 158
  • Views 20536
  • Members are here 0
More Content

Routing Angle

archive

Hi, can we change the routing angle using skill, currently we can change it to "off, 45, 90", is there a setting in allegro that we need to change so we can route signal using other routing angle like "10" thanks


Originally posted in cdnusers.org by aries
Parents

  • Hi,

    "Could you route these special traces manually (using 0/45/90) then use a SKILL routine to skew them by the desired angle?" -- i was hoping that somebody can come up on how we could materialze this idea using skill, as for the skewing the board during fabrication may have some problems, especially when the required sigals to be routed with angle are high speed signals only and we are dealing with multi layered boards

    thanks


    Originally posted in cdnusers.org by aries
Reply

  • Hi,

    "Could you route these special traces manually (using 0/45/90) then use a SKILL routine to skew them by the desired angle?" -- i was hoping that somebody can come up on how we could materialze this idea using skill, as for the skewing the board during fabrication may have some problems, especially when the required sigals to be routed with angle are high speed signals only and we are dealing with multi layered boards

    thanks


    Originally posted in cdnusers.org by aries
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.