• Skip to main content
  • Skip to search
  • Skip to footer
Cadence Home
  • This search text may be transcribed, used, stored, or accessed by our third-party service providers per our Cookie Policy and Privacy Policy.

  1. Community Forums
  2. Design Entry HDL
  3. How to create a compressed BOM in Allegro schematic in Design...

Stats

  • State Suggested Answer
  • Replies 3
  • Answers 1
  • Subscribers 23
  • Views 4892
  • Members are here 0
More Content

How to create a compressed BOM in Allegro schematic in Design Entry

heidi099
heidi099 over 1 year ago

I am using the Allegro Design Authoring : Design Entry HDL and I have a compiled and annotated schematic.

I want to create BOM. 

Part1, 3, R1, R2, R3

Part2 , 4, C1, C2, C3, C4

Part3 , 1 C10, C11

etc

How do I set up the template to create such an output.

  • Sign in to reply
  • Cancel
Parents
  • rg13
    0 rg13 over 1 year ago

    If you want to have components separated based on their value in BOM, you can 'customize' template and choose 'value' under 'Physical part Specifications' as shown below:

    After it, you will find BOM as follows:

    Hope it helps!

    • Cancel
    • Vote Up 0 Vote Down
    • Sign in to reply
    • Verify Answer
    • Cancel
Reply
  • rg13
    0 rg13 over 1 year ago

    If you want to have components separated based on their value in BOM, you can 'customize' template and choose 'value' under 'Physical part Specifications' as shown below:

    After it, you will find BOM as follows:

    Hope it helps!

    • Cancel
    • Vote Up 0 Vote Down
    • Sign in to reply
    • Verify Answer
    • Cancel
Children
  • heidi099
    0 heidi099 over 1 year ago in reply to rg13

    I was created as shown in the picture below.

    How can I get RefDes with the same part number in the same compartment?

    partnumber, value , RefDes, Qcy

    001001, 200k, R1 R2 R3, 3

    001002, 100N, C1 C2, 2

    What filter should I add?

    • Cancel
    • Vote Up 0 Vote Down
    • Sign in to reply
    • Verify Answer
    • Cancel
  • rg13
    0 rg13 over 1 year ago in reply to heidi099

    Refer below settings:

    It seems that you have selected Unique radio button under RefDes. Try to have setting as shown in above image and see if it helps.

    • Cancel
    • Vote Up +1 Vote Down
    • Sign in to reply
    • Verify Answer
    • Reject Answer
    • Cancel
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.

© 2025 Cadence Design Systems, Inc. All Rights Reserved.

  • Terms of Use
  • Privacy
  • Cookie Policy
  • US Trademarks
  • Do Not Sell or Share My Personal Information