Stats

  • Locked Locked
  • Replies 7
  • Subscribers 165
  • Views 15406
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Fanout by Pick creating duplicate vias

mvonahnen

 I am getting a strange problem when I use Fanout by Pick.  When I fanout a new part, it adds vias to previously fanned out parts, stacking multiple vias on top of each other.

 I have deselected the previously fanned out part and even have done other commands in between the Fanout commands.

 Has anybody else seen this?

Parents
  • steve

    What version of Allegro/Orcad are you using ? I just tried this on 16.01 and 16.2 and cannot get the replication. Also what DRC checking does Fanout by pick give you that create fanout does not ?

Reply
  • steve

    What version of Allegro/Orcad are you using ? I just tried this on 16.01 and 16.2 and cannot get the replication. Also what DRC checking does Fanout by pick give you that create fanout does not ?

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.