Stats

Locked Locked
Replies 7
Subscribers 166
Views 16726
Members are here 0

Crosshatch shape problem

Hi all,

I am using Orcad PCB editor 16.0 In my board I need to put hatch plane on top layer connected to GND. I am able to draw hatch shape with proper net name. But, after I observed that it's overlapping on all the pads. Its not taking pad clearence even i set the constraint manager and global shape parameter. I am getting lot of errors since all the pads are shorted with shape.

and one more thing is that its not getting thermal relief for related pads.

what could be the wrong in this case?

thanks

prasanna

Parents

steve over 16 years ago

Try Display - Status, then "update to smooth" button.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

steve over 16 years ago

Try Display - Status, then "update to smooth" button.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.