Stats

Locked Locked
Replies 5
Subscribers 164
Views 12949
Members are here 0

Need Help with PCB SI

Hi,

I have used HyperLynx in the past to do SI. Now I have to use PCB SI. My flow with HyperLynx was to read in the design then run a batch mode simulation. Based on the results from the batch mode then I would pick a net at a time and run detailed analysis. Is there a feature like that in PCB SI where I can run a batch simulation that will do Reflection and Crosstalk on the entire design.

Thank You

Sudhir

Parents

archive over 16 years ago

Hi Dennis

We have PCB SI L. If I have PCB SI L what is my flow. The tutorial talks about Allegro PCB Editor which I cannot open. Which tool do I use to open the .brd file ?

Thank You

Sudhir
Cancel
Vote Up 0 Vote Down

Cancel

Reply

archive over 16 years ago

Hi Dennis

We have PCB SI L. If I have PCB SI L what is my flow. The tutorial talks about Allegro PCB Editor which I cannot open. Which tool do I use to open the .brd file ?

Thank You

Sudhir
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.