Stats

  • Locked Locked
  • Replies 5
  • Subscribers 164
  • Views 13576
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

a problem with design size when plotting the design.

blackflowers

hi,i'm having troubles with a board design. The pads sizes and spaces are right but when i print the board, everything is a bit smaller.        I show you some captures where you can see my design parameters (if you can't see it right, click to zoom):

 

here you can see the grid setup (the  cells are separated 0.05 inches): img36.imageshack.us/.../clipboard01ocr.jpg   

here the package of the component (pitch  is 0.1 inches so it's two cells):  img14.imageshack.us/.../clipboard02vwg.jpg 

and here are the plot parameters:      img17.imageshack.us/.../clipboard01fjd.jpg

 

¿why the size footprint doesn't match with the component when i plot the design?

 

 

Parents
  • blackflowers

    it's not because of the grid settings. I tyed changin all spaces to 0.1 but the result was the same. 

Reply
  • blackflowers

    it's not because of the grid settings. I tyed changin all spaces to 0.1 but the result was the same. 

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.