Stats

Locked Locked
Replies 7
Subscribers 164
Views 18634
Members are here 0

Fix error in schematic HDL

Hi all, I am a new designer in HDL, so I need more help from you Can you help me fix this error? "ERROR(SPCOCN-1993): An error occurred because no value was specified for a placeholder (?). Make sure that you specify a valid value for the placeholder. (placeholderprops)" Where is ERROR(SPCOCN-1993) in help of Cadence tks

Parents

Jerry GenPart over 16 years ago

Hi,

I'm not near my work computer today, so I can't look-up the exact error, but this means that a property exists on the symbol with a value of "?". You need to replace this ? Value with a real value. Typically, this is done by selecting a row from the part table when adding the part via the Component Browser. Try doing this, save the page, and run Export Physical again.

Regards,
Jerry Grzenia
Cancel
Vote Up 0 Vote Down

Cancel

Reply

Jerry GenPart over 16 years ago

Hi,

I'm not near my work computer today, so I can't look-up the exact error, but this means that a property exists on the symbol with a value of "?". You need to replace this ? Value with a real value. Typically, this is done by selecting a row from the part table when adding the part via the Component Browser. Try doing this, save the page, and run Export Physical again.

Regards,
Jerry Grzenia
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data

Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.