Stats

  • Locked Locked
  • Replies 1
  • Subscribers 165
  • Views 12672
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Tooling corner

kabalee

hi

how to assign  (subclass) tooling corners in (class)  board gemetry ?

and

how to assign the  PHOTOPLOT_OUTLINE in board file? use of photoplot outline?

Parents
  • oldmouldy

    Add>Line, set the Class to Board Geometry and the sub-class to Tooling Corners, set the line width as required.

    Add>Rectangle. set the Class to Manufacturing and the sub-class to Photoplot Outline. Note that NO DATA will be plotted to the artwork from beyond the photoplot outline defined, which is why most folks let this default to the drawing size.

Reply
  • oldmouldy

    Add>Line, set the Class to Board Geometry and the sub-class to Tooling Corners, set the line width as required.

    Add>Rectangle. set the Class to Manufacturing and the sub-class to Photoplot Outline. Note that NO DATA will be plotted to the artwork from beyond the photoplot outline defined, which is why most folks let this default to the drawing size.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.