Stats

  • Locked Locked
  • Replies 1
  • Subscribers 164
  • Views 633
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

get drc's on pin delays when i change my cross-section brd thickness

jdkelly

after my brd was designed i changed my cross section to input the correct info and my board thickness changed and i now get tons

of drc's on my matched lengths. i unchecked Z-axis delay and it still gives drc's. i want the correct cross section thickness,

but i don't want to change tons of matched lengths

Parents
  • redwire

     Did you re-run DRC check?  Some of these DRC's are sticky and you have to manually recheck DRC to clear.

Reply
  • redwire

     Did you re-run DRC check?  Some of these DRC's are sticky and you have to manually recheck DRC to clear.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.