Stats

  • Locked Locked
  • Replies 4
  • Subscribers 164
  • Views 1401
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Manual route problem - PCB Editor V16.3

shangwu

I’m trying to route some traces manually.  However, it’s really hard to connect to the centers between pads (shows the triangular symbol indicating it’s not connected).  I have to zoom in a lot and sometimes it still does not “latch” to the center of the pad/pin.  I tried gridless, but does not help.  Most of time I can right click and choose finish to have it connected, but does not always work.  Is there any better solution on this?

Thanks.

Parents
  • shangwu

     Yes, that was the problem.  Thank you.

Reply
  • shangwu

     Yes, that was the problem.  Thank you.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.