Stats

  • Locked Locked
  • Replies 2
  • Subscribers 163
  • Views 15732
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ecl attached property etch length report

purikku22

 hi all,

 is there a way to output only in a report the signals with attached ecl property? 

 for example, SERDES signals. The etch lenght reports  seems to output all the nets.

thanks

Parents
  • mcatramb91
    Hi,
    You can either run the ECL Long and Short Reports from a DOS prompt using the Report command.

    ECL Long will report pin path length, total length and number of vias for all nets with the ECL Property attached.

    ECL Short will report total length and number of vias for all nets with the ECL Property attached.

    Type the following to generate a ECL Long report from a DOS Prompt:

    report –v ecl <Allegro .brd file> <output report file name>

    Type the following to generate a ECL Short report from a DOS Prompt:

    report –v ecs <Allegro .brd file> <output report file name>

    I could not find these reports from the Allegro GUI but they still seem to be available from the batch report command.

    Other alternatives are to create a custom extract view to generate a report or filter the nets out in Constraint Manager then export the active worksheet to Excel but these two reports are readily available and could be easily generated.

    Hope this helps,

    Mike Catrambone
    Plexus Engineering Solutions
Reply
  • mcatramb91
    Hi,
    You can either run the ECL Long and Short Reports from a DOS prompt using the Report command.

    ECL Long will report pin path length, total length and number of vias for all nets with the ECL Property attached.

    ECL Short will report total length and number of vias for all nets with the ECL Property attached.

    Type the following to generate a ECL Long report from a DOS Prompt:

    report –v ecl <Allegro .brd file> <output report file name>

    Type the following to generate a ECL Short report from a DOS Prompt:

    report –v ecs <Allegro .brd file> <output report file name>

    I could not find these reports from the Allegro GUI but they still seem to be available from the batch report command.

    Other alternatives are to create a custom extract view to generate a report or filter the nets out in Constraint Manager then export the active worksheet to Excel but these two reports are readily available and could be easily generated.

    Hope this helps,

    Mike Catrambone
    Plexus Engineering Solutions
Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.