Stats

  • Locked Locked
  • Replies 5
  • Subscribers 166
  • Views 16477
  • Members are here 0
More Content
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Shape to shape clearances

tabbey2656

I have set up 3 different Spacing CSets. (using Orcad 16.3) All the spacing clearances are working as set up

in Constraints except for the positive shapes. They are still just using the default value for spacing which is

much smaller than I need. Has anyone else had this problem?

 

Thanks in Advance,

Tom

Parents
  • steve

    It might be related to the shape parameter settings. Have a look at Shape - Global Shape Parameters, check the Clearances tab and make sure that Thru pin, smd pin and via all reference DRC as a default.

Reply
  • steve

    It might be related to the shape parameter settings. Have a look at Shape - Global Shape Parameters, check the Clearances tab and make sure that Thru pin, smd pin and via all reference DRC as a default.

Children
No Data
Cadence Guidelines

Community Guidelines

The Cadence Design Communities support Cadence users and technologists interacting to exchange ideas, news, technical information, and best practices to solve problems and get the most from Cadence technology. The community is open to everyone, and to provide the most value, we require participants to follow our Community Guidelines that facilitate a quality exchange of ideas and information. By accessing, contributing, using or downloading any materials from the site, you agree to be bound by the full Community Guidelines.